Facility Profiling And DWS Transactions SOP (Standard Operating Procedure) - User Manual
Standard Operating Procedure (SOP) for Facility Profiling and DWS (Dimensional Weighing System).
Facility Profiling is used to maintain the master data and pin ranges for DWS/PNOP machines sorting. These pin ranges data will be uploaded into DWS/PNOP machines and according to these pin ranges, Workstations & bins will be allocated to articles while scanning
This can be done by following below said procedure:
1. Facility Profiling Master Data Maintenance – To mark facility ID as “DWS” / “PNOP”.
2. Facility Profiling Pincode Mapping - Mapping of facility ID for which bag to be closed.
Facility Profiling Master Data Maintenance
➢ To get the System assisted sorting, first a Facility ID should be marked as “DWS” /“PNOP”.
Menu: ZMOFP_MAS, ROLE: FAC_PROFILING. Preferably at Divisional Level.
a. DWS – Offices in which Dynamic Weighment System was implemented
b. PNOP – Offices in which Dynamic Weighment System not implemented but
require the System assistant sorting feature.
Type “ZMOFP_MAS”
DWS / PNOP: As per the preference selects “DWS” / “PNOP”.
Execute.
Message will be shown in the screen with type of Office.
Delete: This deletes only the Office name from DWS / PNOP mapping
Confirmation popup will be shown in the screen. Click on “Yes” to proceed.
Message will be shown after deletion
No comments
It's all about friendly conversation here at postalstudy. I'd love to hear your thoughts!
Be sure to check back again because I do make every effort to reply to your comments here.